From b10a1ee0af8b0eb6698ea4edee477e6ede5164f7 Mon Sep 17 00:00:00 2001 From: Mauro Carvalho Chehab Date: Thu, 22 Nov 2007 13:48:04 -0200 Subject: Remove firmware reload hack for analog From: Mauro Carvalho Chehab On some cases, xc2028/xc3028 wents into "turn off" mode. It seems that this happens when very weak signals are tuned. To solve this, specific standard reaload were done previously. Christopher patches changed this behavior to a complete firmware reload. This patch removes the hack. A much cleaner solution for this trouble is just to sent a xc2028/3028 software reset. Signed-off-by: Mauro Carvalho Chehab --- linux/drivers/media/video/tuner-xc2028.c | 15 ++++++++++----- 1 file changed, 10 insertions(+), 5 deletions(-) --- linux/drivers/media/video/tuner-xc2028.c | 15 ++++++++++----- 1 file changed, 10 insertions(+), 5 deletions(-) (limited to 'linux/drivers') diff --git a/linux/drivers/media/video/tuner-xc2028.c b/linux/drivers/media/video/tuner-xc2028.c index 03fcb8b0a..d8e89ea54 100644 --- a/linux/drivers/media/video/tuner-xc2028.c +++ b/linux/drivers/media/video/tuner-xc2028.c @@ -865,16 +865,21 @@ static int generic_set_tv_freq(struct dvb_frontend *fe, u32 freq /* in Hz */ , mutex_lock(&priv->lock); - /* HACK: It seems that specific firmware need to be reloaded - when watching analog TV and freq is changed */ - if (new_mode != T_DIGITAL_TV) - priv->cur_fw.type = 0; - tuner_dbg("should set frequency %d kHz\n", freq / 1000); if (check_firmware(fe, new_mode, std, bandwidth) < 0) goto ret; + /* On some cases xc2028 can disable video output, if + * very weak signals are received. By sending a soft + * reset, this is re-enabled. So, it is better to always + * send a soft reset before changing channels, to be sure + * that xc2028 will be in a safe state. + * Maybe this might also be needed for DTV. + */ + if (new_mode != T_DIGITAL_TV) + rc = send_seq(priv, {0x00, 0x00}); + if (new_mode == T_DIGITAL_TV) { offset = 2750000; if (priv->cur_fw.type & DTV7) -- cgit v1.2.3