From e6999e9b3a5f584de2f40ca833effe5ff5636f6a Mon Sep 17 00:00:00 2001 From: Klaus Schmidinger Date: Sun, 29 Oct 2000 13:17:22 +0100 Subject: Implemented 'Schedules' menu --- HISTORY | 25 +++++++++++++++++++++++++ 1 file changed, 25 insertions(+) (limited to 'HISTORY') diff --git a/HISTORY b/HISTORY index 717102a6..012f54d4 100644 --- a/HISTORY +++ b/HISTORY @@ -241,3 +241,28 @@ Video Disk Recorder Revision History - The "Blue" button in the "Main" menu can now be used to "Resume" a previously stopped replay session (suggested by Martin Hammerschmid). - The low and high LNB frequencies can now be changed in the "Setup" menu. + +2000-10-29: Version 0.67 + +- The EIT information is now gathered in a separate thread. +- While the "current/next" information is being displayed (either after switching + channels or due to pressing the "Ok" button in normal viewing mode), the "Green" + and "Yellow" button display detailed information about the current/next broad- + cast (if such information is available). +- The sytem time can now be synchronized to the time broadcast in the DVB data + stream. This can be enabled in the "Setup" menu by setting "SetSystemTime" to + 1. Note that this works only if VDR is running under a user id that has + permisson to set the system time. +- The new item "Schedule" in the "Main" menu opens VDR's EPG (thanks to Robert + Schneider). See the MANUAL file for a detailed description. +- The new setup parameters MarginStart and MarginStop define how long (in + minutes) before the official start time of a broadcast VDR shall begin + recording, and how long after the official end time it shall stop recording. + These are used when a recording is programmed from the "Schedules" menu. +- The delay value in the dvb.c.071.diff patch to the driver has been increased + to '3', because on some systems the OSD was not displayed correctly. If you + are running an already patched version 0.71 driver and encounter problems + with the OSD, please make sure the parameter in the ddelay call is '3', not + '2'. +- Fixed initializing the RCU remote control code (didn't work after switching + on the system). -- cgit v1.2.3