From 726225e083aeab7d8ecc1471cabc0786517a4450 Mon Sep 17 00:00:00 2001 From: Klaus Schmidinger Date: Sun, 30 Sep 2001 12:35:09 +0200 Subject: Providing channel number and file name to the shutdown program --- INSTALL | 8 +++++++- 1 file changed, 7 insertions(+), 1 deletion(-) (limited to 'INSTALL') diff --git a/INSTALL b/INSTALL index b942603e..7b3e070e 100644 --- a/INSTALL +++ b/INSTALL @@ -109,7 +109,7 @@ active, the user has been inactive for at least MinUserInactivity minutes and the next timer event is at least MinEventTimeout minutes in the future (see the Setup parameters in MANUAL). -The command given in the '-s' option will be called with two parameters. +The command given in the '-s' option will be called with four parameters. The first one is the time (in UTC) of the next timer event (as a time_t type number), and the second one is the number of seconds from the current time until the next timer event. Your program can choose which one to use @@ -129,6 +129,12 @@ and only perform the system shutdown. A program that uses the second parameter to set the hardware for restart must therefore also check whether the first parameter is '0'. +The third parameter contains the number of the channel that will be recorded +by the next timer (or 0 if no timer is present), and the fourth parameter +contains the file name of the recording as defined in the timer (or an empty +string if no timer is present). These can be used by the shutdown program to +show that information on some display interface etc. + If a timer is currently recording, the parameters will reflect the start time of that timer. This means that the first parameter will be a time in the past, and the second parameter will be a negative number. This only -- cgit v1.2.3