From cd10b439d0465afa6bce38188a4e9d8a5e74d859 Mon Sep 17 00:00:00 2001 From: Klaus Schmidinger Date: Wed, 21 Aug 2013 11:02:52 +0200 Subject: Added basic support for positioners to control steerable satellite dishes --- MANUAL | 22 ++++++++++++++++++++++ 1 file changed, 22 insertions(+) (limited to 'MANUAL') diff --git a/MANUAL b/MANUAL index cce2b0a5..e698085d 100644 --- a/MANUAL +++ b/MANUAL @@ -776,6 +776,28 @@ Version 2.0 are connected to the same sat cable must be set to the same number here. + Use dish positioner = no + By default, the 'P' command code in DiSEqC command sequences + is ignored. Set this parameter to 'yes' if you are using a + satellite dish positioner. + + Site latitude (degrees) = 0 + Site longitude (degrees) = 0 + Set these to the latitude and longitude of your dish's + location if you use a satellite dish positioner. Use the + "Green" key to switch between north/south and east/west, + respectively. + + Max. positioner swing (degrees) = 65 + Defines the maximum angle by which the positioner can move + the dish away from due south (or north) in either direction. + The valid range is 0...90. + + Positioner speed (degrees/s) = 1.5 + Defines the speed at which the positioner moves the dish. + The valid range is 0.1...180. This value is used to calculate + how long it takes the positioner to reach the target position. + CAM: n CAM Name Shows the CAM slots that are present in this system, where -- cgit v1.2.3