merge: http://linuxtv.org/hg/~mkrufky/v4l-dvb

From: Mauro Carvalho Chehab <mchehab@infradead.org>



Signed-off-by: Mauro Carvalho Chehab <mchehab@infradead.org>

1 files changed, 39 insertions, 7 deletions

diff --git a/linux/drivers/media/dvb/dvb-usb/m920x.h b/linux/drivers/media/dvb/dvb-usb/m920x.h
index c354196ff..7dd3db65c 100644
--- a/linux/drivers/media/dvb/dvb-usb/m920x.h
+++ b/linux/drivers/media/dvb/dvb-usb/m920x.h
@@ -19,17 +19,49 @@
 
 #define M9206_MAX_FILTERS 8
 
-#define M9206_I2C_TUNER	0
-#define M9206_I2C_DEMOD	1
-#define M9206_I2C_MAX	2
+/*
+sequences found in logs:
+[index value]
+0x80 write addr
+(0x00 out byte)*
+0x40 out byte
+
+0x80 write addr
+(0x00 out byte)*
+0x80 read addr
+(0x21 in byte)*
+0x60 in byte
+
+this sequence works:
+0x80 read addr
+(0x21 in byte)*
+0x60 in byte
+
+Guess at API of the I2C function:
+I2C operation is done one byte at a time with USB control messages.  The
+index the messages is sent to is made up of a set of flags that control
+the I2C bus state:
+0x80:  Send START condition.  After a START condition, one would normally
+       always send the 7-bit slave I2C address as the 7 MSB, followed by
+       the read/write bit as the LSB.
+0x40:  Send STOP condition.  This should be set on the last byte of an
+       I2C transaction.
+0x20:  Read a byte from the slave.  As opposed to writing a byte to the
+       slave.  The slave will normally not produce any data unless you
+       set the R/W bit to 1 when sending the slave's address after the
+       START condition.
+0x01:  Respond with ACK, as opposed to a NACK.  For a multi-byte read,
+       the master should send an ACK, that is pull SDA low during the 9th
+       clock cycle, after every byte but the last.  This flags only makes
+       sense when bit 0x20 is set, indicating a read.
+
+What any other bits might mean, or how to get the slave's ACK/NACK
+response to a write, is unknown.
+*/
 
 struct m9206_state {
 	u16 filters[M9206_MAX_FILTERS];
 	int filtering_enabled;
 	int rep_count;
-	struct {
-		unsigned char addr;
-		unsigned char magic;
-	}i2c_r[M9206_I2C_MAX];
 };
 #endif